I am sure that I am not using my RB facilities as to its full potential, but could do with advice from more experienced users, I live very close to SEN and its this airport that I have the most intrest in, the other code for this airport is EGCM. I have set the long/lat to the center of the runway, however the monitoring of aircraft is proving difficult as it would seem that the aircraft transponders are turned of when near this airport both take of and landing. As a work around to this problem I have havested the Hex and registration code and use these to filter the aircraft in, this is more successful , but when these filtered aircraft are dectected they are normally above 10000 ft and I still do not pick up the landing of take off, I understand that websites like planefinder use information from the RB boxes accross the globe which seem to have a better success rate of picking up aircraft at my location than I do. Has anybody got any explanations of what could be wrong.