anything
AirNav RadarBox
Welcome, Guest. Please login or register.
Did you miss your activation email?

Login with username, password and session length
 


« previous next »
Pages: [1]

Author Topic: RB and BTS  (Read 3240 times)

0 Members and 1 Guest are viewing this topic.

e

  • New Member
  • *
  • Posts: 2
RB and BTS
« on: March 25, 2008, 12:44:01 PM »
Hi

I'm planning to buy RB and mount its antenna with preamp on my mast on the roof.
There're also GSM BTS antennas not far away from my mast (roughly 2 meters),
although my ham radio antennas are above their level. Will such close vicinity
cause any undesirable effects - like lessened sensitivity or rx blocking in
RB ?

Logged

AirNav Support

  • AirNav Systems
  • Hero Member
  • *****
  • Posts: 4125
Re: RB and BTS
« Reply #1 on: March 25, 2008, 02:05:44 PM »
Best to place is higher than anything else. Not exactly farmilar with the GSM BTS antennas, what frequency are they working at?
Logged
Contact Customer/Technical support via:
http://www.airnavsystems.com/contact.html
[email protected]

e

  • New Member
  • *
  • Posts: 2
Re: RB and BTS
« Reply #2 on: March 25, 2008, 02:29:06 PM »
BTS tx range is 925-960 MHz, this one tx at
~940.300MHz
~945.300MHz
~946.300MHz
~950.000MHz
~952.600MHz
Logged

AirNav Support

  • AirNav Systems
  • Hero Member
  • *****
  • Posts: 4125
Re: RB and BTS
« Reply #3 on: March 25, 2008, 02:37:18 PM »
Its not a million miles away from 1090mhz which ADS-B uses. So anything TX close by might have an effect.

We have not tested this device so I can't give a 100% definate answer but I would say there would be affect if its transmiting nearby.
Logged
Contact Customer/Technical support via:
http://www.airnavsystems.com/contact.html
[email protected]
Pages: [1]
« previous next »