anything
AirNav RadarBox
Welcome, Guest. Please login or register.
Did you miss your activation email?

Login with username, password and session length
 


Author Topic: USB Problem solved!  (Read 6644 times)

0 Members and 1 Guest are viewing this topic.

Boudewijn

  • New Member
  • *
  • Posts: 19
USB Problem solved!
« on: May 31, 2018, 09:07:36 AM »
A tip if you have the same problem. In the night when there were fewer flights my ANRB received fine and worked neatly without interruptions. However, when more and more flights were received on the day, the USB connection was lost. After a long search, the problem was found! The power of the internal USB port is insufficient when it receives too many flights. The solution was simple: a USB-hub with its own power supply. Problem fixed. My ANRB is now running for days without any interruptions!

neroon79

  • Hero Member
  • *****
  • Posts: 4657
Re: USB Problem solved!
« Reply #1 on: June 01, 2018, 05:44:59 AM »
Just for info:

With 3500 particular aircraft resulting in 6500 to 7500 flight movements per day, I noticed, that the ANRB software destabilizes, if it is run for more than a week without any restart of the software. Therefore I set up an automatic protocoll that closes ANRB software, then doing a back-up of MyLog.db and then stating ANRB again. The protocoll is launched each night during times of very low airtraffic and needs about 6 minutes to complete.

Ingo
Greetings from northern Germany, Ingo
11.75nm ESE of EDDV

SW: ANRB v5.00.072/6.01.001 on WIN10 64Bit Pro&Home
HW:
Ant.: DPD Productions ADS-B Vertical Outdoor Base Antenna
AMP: Kuhne electr. KU LNA 1090 A TM
Cable: 25m of ECOFLEX 15+
NB: Asus P53E 24/7 op.
PC: 28"4K + 24" Monitor
AirSpy mini @RPi3

Boudewijn

  • New Member
  • *
  • Posts: 19
Re: USB Problem solved!
« Reply #2 on: June 01, 2018, 05:43:07 PM »
Hi Ingo,

ays without any problems. Five days ago the ANRB was suddenly offline for several hours and then went online again. I saw this on the laptop while I was at the campsite. Fortunately, the software had gone further.
When I researched the cause at home it turned out that it was caused by the Anti Virus software. Automatic updating was enabled and that was the cause. The program is no longer automatic.
You have solved the problem nicely. I assume you wrote a script yourself?

grtz Boudewijn