Altitude values

[gcopter1]

I'm trying to enter, in the quick filter area, an altitude of <4,000 ft. in order to display nearby aircraft flying at or below that altitude.

Problem is, whenever I start typing, the box where the value is entered, immediately auto populates some crazy value way above my desired input.

Just how would I enter 4,000 feet?

For example, when I start typing "4", the value box immediately adds four zeroes and I end up with 40000.

Typing 4000, and pressing the "Filter" button, I still end up in the aircraft list, with flights well above 4000.

[Runway 31]

Try doing it through Advanced Filters where you can set through base and top

See attached

Alan

[gcopter1]

I'm aware of that one as well. I wanted to use the one above the display where I can see the flight info, as in the picture.

The advanced filter I've enabled already to reduce clutter in my map.

Want to do the same to reduce clutter in the list.

[gcopter1]

Think I finally figured it out.

I need to lead the entry with a "0".

In example, for an altitude of 4,000, I enter 04000.

[Runway 31]

Well done.  In case you are interested you can download logos etc from Rods download page http://www.rodbearden.com/RadarBox/Downloads.htm

Alan

[gcopter1]

Thanks.